Indoor COB P1.56 Display
Model: P1.56-54S COB
Module size: 150*168.75mm
Package mode: 4*7mil wafer
Pixel resolution: 96dots(W)*108dots(H)
Cabinet size: 600*337.5mm
Cabinet resolution: 384dots(W)*216dots(H)
- Fast Delievery
- Quality Assurance
- 24/7 Customer Service
Product Introduction
COB P1.56 Indoor Full Color Display
Product Features:
- High reliability: inverted common-shade, better heat dissipation, more stable;
- High Contrast Ratio: Contrast ratio ≥ 5000:1;
- Patented film technology: up to 75% light transmittance, low temperature rise of the screen body;
- Low power consumption: 30% energy saving;
- Pre-maintenance, easy to install: no white edge phenomenon for multiple disassembly and installation of the module.
Picture:
- Panel mounting position.
The corresponding mounting position of each numbered light panel on each cabinet.
-
Correct placement of the panel.
The panel should be taken out of the box or removed from the screen body gently, as shown above.
-
Front view of screen
The above figure shows the corresponding mounting position of each numbered cabinet.
Packaging:
- Panel packaging
- Cabinet packaging
Installation Instructions:
1,Front installation instructions
A, Cabinet fixed: Expansion screws will connect the piece fixed on the force wall, and then from the front of the screws will be used to fix the cabinet in the back of the connecting piece
B, Cabinet assembly: first install the shaft screws (do not tighten), and then install the front connecting piece
C, Wire connection: tighten all the screws, connect the power cord and network cable.
D. Panel assembly: use vacuum suction cup maintenance tool to assemble the panel on the cabinet.
2,Rear installation instructions
A, Cabinet fixed: from the back of the screen body through the rear connecting piece to fix the cabinet on the bracket.
B. Cabinet assembly: install the shaft screws (do not tighten first), then install the front connecting piece
C,Other steps can be referred to the front mounting method.
Precautions for use.
1, contact LED light board and panel need to pay attention to anti-static, need to do the following effective protection: wear a grounded static hand ring or static gloves; screen body should be strictly grounded, grounding resistance ≤ 10 ohms, every half a point inspection every half year.
2, clean the surface of the light board, do not use unknown chemical liquids, can be used to clean dust-free or clean water wet cloth wiped lightly.
3, the requirement of the power distribution box must be configured with surge protectors and other protective facilities.
Hot Tags: indoor cob p1.56 display, China, suppliers, manufacturers, factory, made in China
No Information
