LED Display Screen Body Water Solution

First, to the fastest speed with a fan or other tools to water LED display body completely dry;

Secondly, the fully blown dry screen body is powered on and aging. The specific steps are as follows:

(1) Adjust the brightness (all white) to 10%, and the power aging for 8-12 hours;

(2) The brightness (all white) to 30%, power aging for 12 hours;

(3) The brightness (all white) to 60%, power aging for 12-24 hours;

(4) Adjust the brightness (all white) to 80%, and the power aging for 12-24 hours;

(5) Adjust the brightness (all white) to 100%, and the power aging for 8-12 hours.

Complete the above steps, the LED display body will basically return to normal, but there are the following points in the process of attention:

1, in the warehouse found water or LED display screen body water, should be urgent to deal with it, do not delay time;

2. Organize personnel to blow-dry the LED display screen body of water;

3, do not put the WATER has been LED display screen body into the air box, it is easy to LED light suffocated broken;

4, in the warehouse water, the air box may be water, should be on all the air box exposure, to prevent the water volatilization in the LED display screen after the box;

5, all the water LED display not timely processing may more or less affect the stability of the screen body, in the process of emergency treatment, the screen body power may occur after the phenomenon of constant dead light, which requires manufacturers to pay attention to observe at any time;

6, all the water LED display screen body in the air box. Over 72 hours, the screen body basically has no repair value, should be handled with caution.

To sum up, in the face of the display screen body water treatment, the most need is "as soon as possible" two words, with the shortest time the most effective way to deal with, the longer the time drag, the greater the loss will be, so in the face of warehouse water problems, it is necessary to act immediately.